[. . . ] Remember that this user manual is also applicable for several other models. explanation of symbols Throughout this user manual the following symbols are used: c Important information or useful hints about usage. Packaging materials of the product are manufactured from recyclable materials in accordance with our National Environment Regulations. Do not dispose of the packaging materials together with the domestic or other wastes. [. . . ] The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. The hood should not be used by children or persons not instructed in its correct use. Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard). Motor power Lamp power Air outlet pipe diameter Net weight Gross weight Color Markings on the product or the values stated in other documents supplied with the product are values obtained under laboratory conditions as per relevant standards. These values may vary according to the usage of the product and ambient conditions. 1 Drilling the Support surface and Fitting the Hood screw Fitting · The hood support surface must be 135 mm Above the bottom surface of the wall units. Drill the support with a ø 4, 5 mm drill bit, using Cut a hole ø 120-150 mm in size on the sup- Fix using the 4 screws 12a (4, 2 x 44, 4) provided. The hood can be installed either directly on the Bottom surface of the wall units using snap-on side supports. Cut a fitted opening in the bottom surface of the wall unit, as shown. Lock in position by tightening the screws Vf from underneath the hood. The space between the edge of the hood and the rear wall can be closed by applying the element 20 provided, using the screws supplied for this purpose. Cut a hole ø 125 mm in any shelf that may be positioned over the hood. Connect the flange to the outlet on the shelf over the hood by using a flexible or rigid pipe ø120 mm. Fix the air outlet grid 8 on the recirculation air outlet by using the 2 screws 12e (2, 9 x 9, 5) provided. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Connect the hood to the mains through a twopole switch having a contact gap of at least 3mm. [. . . ] A Warning: Turn the lights off and wait until the lamps cool down before you change the odour filter. These filters are not washable and cannot be regenerated, and must be replaced approximately every four months or more frequently by particularly heavy use. Unscrew the bulbs and replace them with new Ones having the same characteristics. The hood can be installed either directly on the Bottom surface of the wall units using snap-on side supports. [. . . ]